A side profile is a different drawing problem from a front view. The face has one main contour line, the features are arranged along that line, and the depth of the skull matters more than its width. This step-by-step guide starts with basic shapes and works toward a clean profile line, with notes on the eye, ear and jaw and a list of common mistakes.
Start with the skull shape
Block the skull as a simple rounded shape, such as a circle or sphere, with a box-like shape for the jaw below it. Give the skull depth by sketching the back of the head as well as the front. Angle the jaw back toward the neck. Keep the shapes light and loose.
Draw the center guide and eye line
Draw a vertical guide where the front of the face will sit, then a horizontal eye line across the skull at about halfway between the top of the head and the chin. The guides help you keep the features in line as you add them.
Place the eye, ear and jaw
The eye sits on the eye line, set back from the front of the face. The ear often sits near the middle of the skull from front to back, between the brow line and the base of the nose. The jaw line starts under the ear and runs forward toward the chin. At this stage, keep the ear simple: a basic C shape with a clear top and bottom is enough.
Map the profile line
The profile line is the outline of the face from the forehead to the chin. It usually passes through a few landmarks in order: the forehead, the brow ridge, the bridge of the nose, the tip of the nose, the base of the nose, the upper lip, the lower lip and the chin. Mark each point lightly as a small dot first. Then connect the dots and check the line against your reference or a mirror. Profiles vary a lot from person to person, so the reference matters more than any fixed rule.
Refine the outline
Once the dots are connected, refine the line. Use softer curves across the forehead and cheek, and sharper turns at the tip of the nose and the lips. Vary the line weight, as in clean digital line art: keep the outline heavier where the form turns away from the light, and lighter near the eye and ear. Erase the construction lines once the contour reads clearly.
Add the hair as masses
Start the hair as large shapes: the hairline at the forehead, the volume over the skull and the flow down the back of the head. If the hair is pulled back, keep the front hairline clean. Add detail only after the shape reads.
Shade for side light
Choose a light direction and shade the planes. For more on light placement, see lighting setups for digital painting. Often the forehead and nose catch the light, while the cheek and jaw sit in shadow. Keep the shadow under the brow and nose clear, since that shadow helps the profile read as three-dimensional. Use soft shading on the cheek and a sharper edge on the shadow under the nose.
Common mistakes
- Nose too long or too short: check it against the eye line and the base of the nose, which sits roughly two-thirds of the way down from the top of the head.
- Ear placed too far forward or back: check it against the middle of the skull.
- Jaw disconnected from the ear: the jaw line should start under the ear.
- Flat skull: without depth at the back of the head, the profile looks like a cutout.
- Features drawn before the skull: the features float unless the head shape comes first.
Next steps
For the front-facing structure that helps you check a profile, read the face proportions guide. For the basic head-building steps, see how to draw portraits for beginners. Once the outline works, the digital skin guide covers shading and color.